What should I pay attention to when using Sealing Wax Sticks?

Confirm the cotton core of Sealing Wax Sticks, the length is 1CM is appropriate. Too long or too short will affect the quality, too long may cause the Sealing Wax to be blackened and covered with a lot of black spots, too short may not burn.

After the above steps are confirmed, you can operate. In addition, it is recommended that the space be kept dry and ventilated, the workbench should be covered with newspaper, and the workbench should have a large enough position. That's how you can put your skills to use.

After the wax core is lit, pay attention to the angle of the sealing wax stick. Generally, the wax stick is at an angle of 30-60 degrees to the horizontal plane. Try not to let the flame burn directly on the sealing wax stick, otherwise the dripping wax will turn black. Because some people are in a hurry and hold the wax strip upright, the wax liquid can easily extinguish the flame, and it is also possible to drip the flamed wax onto the paper, affecting safety.

Secondly, in the process of burning, the paint strip should be turned at any time to make it melt evenly by heat.

In this way, the dripping wax liquid. The color is pure, and then stamped with its own LOGO. Note that after the seal is covered, if it is difficult to pull it out, don't pull it hard, you should let it cool before pulling it out.

Another thing to remind everyone is that every time you use up Sealing Wax Sticks, turn it off, and be sure to use scissors to cut off the cotton core with ash. This can avoid affecting the next use.